| |
The new generation Telephone
Adapter of NTCL nonbrand VoIP series supports high quality
telephone, fax services and Router functions in the
same box. Simply plug it into your DSL or cable Internet
connection and use the standard telephone jacks to connect
your existing phones or fax machines. Within few steps
of configuration, it becomes the Router of your home
network and an Internet telephony gateway.
This Telephone Adapter is compatible with most of the
features such as Caller ID, Call Waiting, Call Transfer,
Call Forwarding, and Voicemail are supported. By selecting
NTCL as your service provider, you can start to make
calls at low long distance and international phone rates
with it. Its compact size and stylish outline makes
it suitable for business travelers to use in any place
with Internet connection over the trip. In places where
computer is not available, it can be set up by a telephone
via voice prompt.
|
|
 SIPv2
(RFC3261) compliance
SIP
METHOD: ACK, BYE, CANCEL, INFO, INVITE, NOTIFY OPTIONS,
PING, PRACK,
 PUBLISH,
REFER, REGISTER, SUBSCRIBE, UPDATE
SIP
Extension: Session Timer (update or re-invite), Proxy-Require,
P-Asserted (RFC3325),
MWI
(RFC3842)
Voice
Compression: G.711 a µ-law , G.726, G.729A, G.723.1
Silence
suppression & detection
G.165/G.168
Echo Cancellation
Out-of-band
DTMF relay: RFC2833 or SIP INFO
Termination
Impedance: 600O, 900O & complex Impedance
Failover
SIP Proxy server registrations
Failsafe
mechanism (FXS relay to PSTN ): Network failure, Service
unavailable, Power loss
T.30
FAX pass through, T.38 real time FAX relay
Caller
ID: DTMF, FSK-Bellcore, FSK-ETSI detection and generation
Polarity
reversal detection (FXO ) and generation (FXS )
Recordable
greeting message (supported)
Hunting
number support (for multiple port models)
Emergency
number table (supported)
E.164
numbering, ENUM support
Hot
line, Warm line support
Call
Features:
-- Call
Hold, Call Waiting, Call Pickup
-- Call
Forward – Unconditional, Busy, No Answer
-- Call
Transfer - Unattended, Attended
-- Speed
Dialing, Repeat Dialing, Three Way Calling (Media Server
required)
 WAN:
One
10/100Mbps auto-crossover Ethernet port
WAN
type: Static IP, PPPoE, DHCP, PPtP, BigPond Internet
VPN:
PPtP client
QoS:
IP Precedence, DiffServ
VLAN:
IEEE802.1Q
NAT
Traversal: Outbound Proxy, STUN, UPnP
SIP
and RTP Priority Queuing
RTP
Packet Summary: sent, received, loss packet count
NTP:
3 Time Servers, Time Zone support
DDNS:
DynDns.ORG, TZO, Peanut Hull, 3322.ORG
MAC
Address Clone
RJ-45
Connector
LAN:
One
10/100Mbps auto-crossover Ethernet port
Router
or Bridge mode
NAT
/ PAT (RFC1631 / RFC3235):
--
Virtual Server, DMZ
--
DHCP Server (RFC 2131 / RFC2132)
Firewall:
MAC Filter, IP Filter, Port Filter
Management:
LEDs:
Power/Alarm, VoIP, WAN, LAN, Phone/Line
Web-based,
TELNET and telephone keypad configuration
Password
controlled administration
Remote
firmware upgrade via TFTP or FTP
Auto
Provisioning enabled
Inbuilt
PING tool
Multi-function
reset button: reset, restore default
General:
Adapter: AC 100~240V, 50/60Hz, DC 12V output
Temperature:
0°C ~ 45°C (operation), -25°C ~ 75°C
(storage)
Humidity:
10% to 90%RH, non-condensing
Dimension:
96w x 135d x 38h mm
Net
Weight: 0.16kg
Gross
Weight: 1.05kg
|
